Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 3008
    4. : Interior filter replacement peugeot 3008

Peugeot 3008 - Video tutorial

Model: Peugeot 3008 P84, MK 2 - Years 2016-2023
Part: Cabin air filter
Operation: Interior filter replacement peugeot 3008

Position yourself under the glovebox and, with the aid of a lever, extract the clips of the plastic cover, press on the 3 fixing levers and extract the cover. Using an Allen wrench, proceed by unscrewing the three screws highlighted below and inside the glovebox to access the cover cap of the cabin filter housing, open it by pulling it towards you, extract the old cartridges (with the help of pliers) and insert the new ones respecting the direction of the arrow shown above. Close the housing cap, retighten the three Allen screws under and inside the glovebox and replace the cover cap by reinserting the two pressure clips.


Posted on 12 November 2023 by ScegliAuto

This video is currently unavailable

    Frequently Asked Questions

    • 3008 2016-2023 - Where is the Peugeot 3008 cabin air filter located? Read Answer
    • 3008 2016-2023 - Where is the cabin filter of a Peugeot 3008 located? Read Answer
    • 3008 2009-2016 - Where is the Peugeot 3008 antipoline filter located? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos