Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Third Brake Light on a Peugeot 308

Model: Peugeot 308 T7, MK 1 - Years 2007-2014
Part:

Before you start, open the boot of your Peugeot 308. Begin by unfastening and removing the internal cover near the third brake light. Next, unscrew and remove the nuts securing the third brake light to the tailgate, then detach the clip. This will free the third brake light, which you can then pull out of its housing. Proceed by disconnecting the electrical connector. At this point, you can remove the bulb holder, take out the blown bulb, and you have completed the disassembly. To install the new bulb and close the third brake light, simply follow these steps in reverse, and you will have successfully completed the replacement.

Updated on 9 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Third Brake Light and Lamp of the Peugeot 308
Replacing the Third Brake Light and Lamp of the Peugeot 308
Peugeot 308 (2013-2021 / T9, MK 2) In this brief and simple guide, follow the main instructions to remove and replace the third brake light and lamp of the Peugeot 308. First, open the…
Removing the Third Brake Light on Peugeot 308 SW
Removing the Third Brake Light on Peugeot 308 SW
Peugeot 308 (2013-2021 / T9, MK 2) In this video tutorial, you will learn how to remove the third brake light on a Peugeot 308 SW by following these simple steps. First, open the boot …
How to Replace the Third Brake Light Bulbs on the Peugeot 308
How to Replace the Third Brake Light Bulbs on the Peugeot 308
Peugeot 308 (2007-2014 / T7, MK 1) If any bulbs in the third brake light located on the upper edge of the tailgate are not lighting, you will need to disassemble it to replace them. It…

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos