Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions

Replacement brake discs and front pads

Model: Peugeot 106 MK 1 - Years 1991-2004
Part: Brake discs

Raise the car on suitable car stands (loosen the fixing pins of the wheels before lifting the car) and remove the wheels. Extract the split pin and then the pin securing the pads to the brake calliper; disassemble the fixing pins of the caliper itself and remove it from the hub by extracting the old pads. Clean the caliper with a suitable detergent foam. Then unscrew the pins fixing the brake disc to the hub and remove the disc itself; clean the hub seat from any oxidation residues and apply the new disc after cleaning it from the protective oil. Tighten the disc fixing pins; re-enter the caliper cylinder with an arc clamp to accommodate the new pads and possibly repaint the calipers red. Then reassemble the calliper to its support, insert the new pads and the relative locking sine with the safety split pin. Finally reassemble the wheel.


Posted on 19 July 2023 by ScegliAuto



How to change the front pads of the Peugeot 106
Peugeot 106 (1991-2004 / MK 1) Change the tablets of the Peugeot 106? Let's see the disassembly of the rear brake pads. We jack the car up to the desired height, remove the wheel (
How to replace the brake pads of a Peugeot 106
Peugeot 106 (1991-2004 / MK 1) Before we can start, we will have to go to engage the first gear and activate the parking brake of our Peugeot 106. Let's start then by going to lift
How to remove the front brake caliper
Peugeot 106 (1991-2004 / MK 1) The following video shows us in just a few short and concise steps, how to remove the front brake caliper of a car. In the images it can be seen that

Other guides that may interest you

How to remove the telepass holder from the windshield

Today we will explain how to remove the telepass holder from a vehicle's windshield. Removing the telepass holder from the windshield is a very simple and quick operation to perform independently, you just need to use nylon thread that you will need to pull towards the holder and pass it between the holder and the clip. After performing this operation, the holder will be removed. There may be glue residues on the windshield that can be removed with a solvent suitable for glass cleaning. After cleaning everything, it is possible to mount another telepass holder on the windshield in the same position as the one removed or elsewhere.

Watch the video!


by ScegliAuto

More videos