Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Brake Master Cylinder

Model: Peugeot 106 MK 1 - Years 1991-2004
Part: Pump

The brake master cylinder is fixed to the brake booster (a device that uses vacuum to reduce the force required on the pedal) and houses the reservoir for the brake fluid: begin the disassembly operation by emptying the reservoir by sucking out the fluid with a syringe; then detach the reservoir by pulling it upwards and disconnect the float connector; unscrew the fastening nuts of the pipes connected to the master cylinder and remove them from their respective seats; at this point, complete the disassembly by unscrewing the fixing pins of the master cylinder to the brake booster.

Updated on 13 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Fuel Pump on a Peugeot 106
Replacing the Fuel Pump on a Peugeot 106
Peugeot 106 (1991-2004 / MK 1) Follow this guide to remove and replace the fuel pump on a Peugeot 106. First, open the boot and start reclining the rear seats; then lift the rear b…
Instructions for Removing the Fuel Pump
Instructions for Removing the Fuel Pump
Peugeot 106 (1991-2004 / MK 1) To access the fuel pump, it is necessary to remove the rear seat cushions: the pump is located inside the tank and is protected by a rubber cap. Remo…
Replacement of Brake Discs and Front Pads
Replacement of Brake Discs and Front Pads
Peugeot 106 (1991-2004 / MK 1) Lift the vehicle on suitable axle stands (loosen the wheel bolts before lifting the vehicle) and remove the wheels. Remove the retaining clip and the…

Other guides you may be interested in

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos