Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 3008
    4. : Replacement of the cabin air filter of the Peugeot 3008

Peugeot 3008 - Video tutorial

Model: Peugeot 3008 P84, MK 2 - Years 2016-2023
Part: Air filter
Operation: Replacement of the cabin air filter of the Peugeot 3008

To keep fuel consumption under control and maintain an efficient engine, it is necessary to replace the air filter of the Peugeot 3008 at the scheduled intervals recommended by the manufacturer. We open the hood of the engine compartment, using a Torx 45 key, we unscrew the three screws that secure the filter cover, we unscrew the clamp of the outlet pipe and remove the cover. This operation requires a bit of patience because we should not force too much on the turbo pipe. To facilitate the operation, we can temporarily remove the brake fluid reservoir. Once the cover is removed, we can slide out the old filter element and replace it with a new one, making sure the rubber edge adheres well. We put the cover back on and insert the outlet pipe, tighten the clamp and the three screws, and reassemble the brake fluid reservoir.


Posted on 26 July 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 3008 2016-2023 - Where is the cabin filter located, in the Peugeot 3008? Read Answer
    • 3008 2009-2016 - Where is the Peugeot 3008 air filter located? Read Answer
    • 3008 2016-2023 - Where is the pollen filter on my paugeot 3008? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos