Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to install an alarm on a Piaggio Beverly

Model: Piaggio Beverly 125
Part: Checks and maintenance

Video tutorial

In this video, a siren is installed as an anti-theft device on this Piaggio Beverly; the control unit is mounted under the seat, in a dry area near the battery, to which the power supply is directly connected via a fuse. Motion sensors are mounted on the handlebars and on the frame for hidden components (such as the siren).

For additional security, a switch is usually mounted in a hidden area. As a final test, a check of the operation is carried out without starting the vehicle, with a test of the engine block and adjustment of the sensitivity of the vibration sensor.

The Beverly has critical points: disassembling the fairings to access the electrical system, protecting the control unit and sensors from water, and being very careful not to cut the original cables.


Posted on 6 October 2025 by ScegliAuto


Related tutorials

How to replace the key battery on a Piaggio Beverly
How to replace the key battery on a Piaggio Beverly
Beverly 125 In this new guide for your 2021 Piaggio Beverly, you will learn how to replace the button battery inside the key. First, obtain a small flat screwdri…
How to open the seat of the Piaggio Beverly with a flat battery
How to open the seat of the Piaggio Beverly with a flat battery
Beverly 125 In today's video, see how to open the seat of the Piaggio Beverly if the service battery is flat. First, open the compartment located on the shield u…
How to Replace the Headlight Bulb on the Piaggio Beverly Tourer 125?
How to Replace the Headlight Bulb on the Piaggio Beverly Tourer 125?
Beverly 125 To replace the headlight bulb on the Piaggio Beverly Tourer 125, first unscrew the five bolts securing the visor, four at the front and one inside. N…

How to Reset the Service Light on a Vespa Sprint 150?

To reset the Service light on a Vespa Sprint 150, insert the ignition key into the corresponding lock. Once turned to activate the instrument panel, press and hold the button located on the right side of the handlebars. Wait a few seconds with the button pressed until the Service light disappears from the instrument panel. Once the light has been reset, release the button and turn off the ignition by turning the key.

Watch the video!


by ScegliAuto

More videos