Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Start by unscrewing the two screws under the handlebar on the rider's side, as clearly shown in the video. Now remove the cover over the screw on the front fairing and unscrew the underlying bolt, taking off the mentioned protection. At this point, extract the fairing where the headlight is fixed and disconnect its connector. Remove the rear rubber cover of the headlight and replace the bulb, then reverse the process for reassembly by replacing the rubber cover and reconnecting the connector. Finally, reattach the fairings and screw the bolts back in. Check the operation of the bulb.

Updated on 13 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the headlight bulb of the Piaggio Vespa 125 LX
How to replace the headlight bulb of the Piaggio Vespa 125 LX
Vespa 125 Lx By following these simple steps, we will see how to disassemble and replace the low beam or high beam bulb of the front headlight of the Piaggio Vesp…
How to replace the headlight bulb on a Piaggio Vespa 125 LX scooter?
How to replace the headlight bulb on a Piaggio Vespa 125 LX scooter?
Vespa 125 Lx In this tutorial, you will see how to replace the headlight bulb on a Piaggio Vespa 125 LX scooter, a very simple and quick operation. First, ensure …
Battery replacement for Piaggio Vespa 125 LX
Battery replacement for Piaggio Vespa 125 LX
Vespa 125 Lx In a few simple steps, we will see the process of disassembling and replacing the battery of the Piaggio Vespa 125 LX. First, we put the scooter on t…

How to Replace the Air Filter in the KTM Adventure 990

In this tutorial, see how to replace the air filter in the KTM Adventure 990, a very simple and quick operation. First, insert the key into the left ignition switch, then turn it and detach the seat from the base. Next, remove the plastic cover from the tank, locate the filter box, and open it by unscrewing the four fastening screws. At this point, remove the old filter, clean the inside of the housing from any dirt residue, and insert the new part. To reassemble everything, simply follow the reverse procedure.

Watch the video!


by ScegliAuto

More videos