Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this video tutorial, you will see how to remove and replace the front brake pads on the Piaggio Beverly 125 and 250 scooter. First, place the scooter on its centre stand and start by unscrewing the bolts of the front brake caliper using an Allen key; then, leverage the caliper piston to retract it, thus removing the old brake pads, as shown in the video. At this point, clean the inside of the caliper from dirt and insert the new high-quality brake pads; all that’s left is to reassemble everything!

Updated on 10 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace Brake Pads on a Piaggio Beverly
How to Replace Brake Pads on a Piaggio Beverly
Beverly 250 In this brief guide, learn how to replace the brake pads on your Piaggio Beverly. It's not a complex task; just take care, and you can do it without …
How to Activate Traction Control on a Piaggio Beverly
How to Activate Traction Control on a Piaggio Beverly
Beverly 250 In this short video, see how to activate and deactivate traction control on a Piaggio Beverly. Traction control on a scooter helps prevent loss of gr…
How to Replace the Fuel Filter on Piaggio Beverly 250
How to Replace the Fuel Filter on Piaggio Beverly 250
Beverly 250 In this video, you will see how to remove and replace the fuel filter on a Piaggio Beverly 250 scooter in simple and quick steps. First, place the sc…

Servicing a Honda SH300 Scooter

How to service the SH 300 scooter. This operation should be done with the engine cold. Remove the cover and take out the air filter, cleaning the compartment where the new one will be placed. Refit the three screws you removed earlier and reassemble the cover. Remove the oil cap, take a 12 mm spanner and unscrew the oil plug from underneath. Allow the oil to drain into a suitable container, which you will then dispose of at an authorised centre. Remove the filter, clean the cavity where the new one will be fitted, and tighten it with the spanner. Refit the oil cap screw. Always change the washer on the cap. Now, refill with oil. You will need a synthetic oil like Motul 5100 10W40, which costs £12.40 per litre on Amazon. If you are doing a complete change, you will need two cans, as you will require 1.6 litres including the filter. After adding the oil, let it rest for a few minutes, then run the engine for a few minutes and check the level. If necessary, top it up: it should be halfway between min and max.

Watch the video!


by ScegliAuto

More videos