Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Piaggio
    3. :
  3. Zip
    4. : How to change the Piaggio Zip engine oil and oil filter

Model: Piaggio Zip
Part: Engine oil
How to change the Piaggio Zip engine oil and oil filter

The routine maintenance service must be carried out on every vehicle on a regular basis to guarantee the correct functioning of the engine; we will see how to replace the engine oil and oil filter of the Piaggio Zip scooter. First we put our scooter on the central stand and start unscrewing the oil vent bolt that we find under the engine, letting it drain into a container for about ten minutes; then unscrew the oil filter screw, removing and replacing the cartridge with the new one. Now unscrew the rod and top up with the new oil!


Posted on 30 October 2022 by ScegliAuto



How do you replace the engine oil of the Piaggio Zip?
Zip In order to replace the engine oil of the Piaggio Zip, you need to loosen the drain plug located in the central lower part of the device, so that you
How to replace the oil in the Piaggio Zip gearbox.
Zip Let's briefly see the instructions that will allow us to replace the transmission oil of the Piaggio Zip scooter in simple and quick steps. First of
How do you replace the Piaggio Zip belt?
Zip In order to replace the Piaggio Zip belt, loosen the bolts that secure the air filter housing, which is located immediately above the transmission on

How to change the Royal Enfield Himalayan engine oil and filter

The guide shows you how to change the Royal Enfield Himalayan engine oil and oil filter. The first operation to perform is to secure the vehicle and turn it on to make the oil fluid. At this point, after having placed protection against splashes under the bleed valve and having prepared a container for the disposal of used oil, with a 22 mm wrench, open the valve. Using an 8 mm wrench, remove the fixing bolts of the inspection hatch of the mesh filter and extract the latter. Refit the clean filter and close the door; install the gasket on the purge valve and tighten it in place. On the opposite side of the vehicle, unscrew the three 8 mm bolts and drain the oil from the filter. Remove the old cartridge and clean the housing. Pour some oil into the new cartridge to facilitate the circulation of the oil. Put everything back in place. Fill the tank to the correct level and run the engine for a few minutes. Check the level again and top up if necessary.

Watch the video!


by ScegliAuto

More videos