Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to reset the service on the Piaggio Vespa Primavera 125 scooter?

Model: Piaggio Vespa 125 Primavera
Part: Service warning light

Video tutorial

In this tutorial, you can see how to reset the 1000 km service on the Piaggio Vespa Primavera 125 scooter, an extremely simple and quick operation to perform only after completing all the work required by the service. First, insert the key, turn on the instrument panel, and start the engine.

Next, press and hold the "MODE" button, located under the throttle grip, to the right for about 15 seconds, or for as long as it takes for the warning light depicting a spanner to disappear completely. To verify that the operation was successful, you can restart the instrument panel.


Updated on 27 June 2026 by ScegliAuto


Related tutorials

How to reset the Service light on the Piaggio Vespa 125 Primavera?
How to reset the Service light on the Piaggio Vespa 125 Primavera?
Vespa 125 Primavera From the instrument panel of the Piaggio Vespa 125 Primavera, you can clear the Service light by inserting the ignition key into the corresponding lo…
How to Replace the Spark Plug on a Piaggio Vespa Primavera 125?
How to Replace the Spark Plug on a Piaggio Vespa Primavera 125?
Vespa 125 Primavera Good morning, today’s guide aims to replace the spark plug on your Piaggio Vespa Primavera 125. Start by removing the side panels of the scooter. Nex…
How to replace the rearview mirror on the Piaggio Vespa 125 Primavera?
How to replace the rearview mirror on the Piaggio Vespa 125 Primavera?
Vespa 125 Primavera To replace the rearview mirror on the Piaggio Vespa 125 Primavera, lift the rubber cap at the base of the mirror support: once this cap is lifted, gr…

How to change the transmission oil on the Honda PCX 150 scooter?

In this tutorial, you will see how to change the transmission oil on the Honda PCX 150 scooter, a very simple and quick operation. First, ensure the engine is completely cold, then locate the three bolts at the end of the casing and position a container underneath them. Next, remove the two inner bolts using a 12 mm socket, clean them of any dirt, and allow all the oil in the system to drain out. At this point, tighten the lower bolt and, using a pump or syringe, add new oil through the upper hole.

Watch the video!


by ScegliAuto

More videos