Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Rear Shock Absorber on a Piaggio Zip

Model: Piaggio Zip
Part: Shocks

Video tutorial

To replace the rear shock absorber on a Piaggio Zip, you need to open the under-seat compartment so that it can be completely removed by unscrewing the fastening screws inside. Once this compartment is fully removed, you will have access to the screw that secures the shock absorber from its upper side.

This screw must be loosened so that you can then unscrew the one at the bottom; by doing this, the old shock absorber can be removed from its housing and then replaced with a new spare part.


Updated on 28 June 2026 by ScegliAuto


Related tutorials

How to Replace the Rear Shock Absorber on a Piaggio Zip?
How to Replace the Rear Shock Absorber on a Piaggio Zip?
Zip To replace the rear shock absorber on the Piaggio Zip, lift the seat to access the rear of the under-seat compartment. Here, remove the plastic cover…
How to Replace the Rear Shock Absorber on a Piaggio Zip?
How to Replace the Rear Shock Absorber on a Piaggio Zip?
Zip To replace the rear shock absorber on the Piaggio Zip, lift the seat to access the lower part of the under-seat compartment. Here, detach the plastic…
How to Change the Gear Oil on a Piaggio Zip
How to Change the Gear Oil on a Piaggio Zip
Zip Here are the brief instructions that will allow you to change the transmission oil on a Piaggio Zip scooter in simple and quick steps. First, place t…

Vespa Immobiliser: How to Transfer the Chip from the Old Key

In the case shown in the video, the new keys are not recognised by the ECU: the Vespa starts but does not run (thus the immobiliser is active). The solution shown in the video involves locating the immobiliser chip in the old key (the one recognised by the ECU). Open the cover on the key (only red master keys or some blue ones), remove the chip (which is a small black cylinder or rectangle), insert it into the new key in place of the new one, and try to start. Now the key will work. If the master key is red, it will definitely work. If it is blue, it might work: you need to cut the silicone; this is possible but a delicate operation. If it is a black clone key, then it is a system that does not work.

Watch the video!


by ScegliAuto

More videos