Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Carburettor from the Piaggio Vespa PX 125 - PX 200

Model: Piaggio Vespa Px 125
Part: Carburetor

Video tutorial

Follow the instructions below to remove the carburettor from the Piaggio Vespa PX 125, as well as the PX 200. First, put the central stand down and start by removing the side panel on the engine side; then unscrew the screws of the air filter cover, removing the intake hose as shown in the video.

At this point, disconnect the fuel line and the throttle cable; unscrew the bolt on the manifold to remove the carburettor, replacing it with a new one or cleaning it, following the video until the end!


Updated on 4 July 2026 by ScegliAuto


Related tutorials

How to Adjust the Carburettor of the Piaggio Vespa PX 125?
How to Adjust the Carburettor of the Piaggio Vespa PX 125?
Vespa Px 125 To adjust the carburettor of the Piaggio Vespa PX 125, locate the bolt at the rear of the carburettor. Here, you will be able to tighten the bolt wit…
How to Remove the Engine from a Piaggio Vespa PX 125 - Lml Star 125
How to Remove the Engine from a Piaggio Vespa PX 125 - Lml Star 125
Vespa Px 125 In this video tutorial, you will learn how to remove the engine from the bodywork of the Piaggio Vespa PX 125 and the LML Star 125. First, place the …
How to Remove the Carburettor on Vespa PX 125 - LML Star 125 2T
How to Remove the Carburettor on Vespa PX 125 - LML Star 125 2T
Vespa Px 125 Watch this video for the main steps to remove and replace the original carburettor on a Vespa PX 125, as well as on the LML Star 125 2-stroke. First,…

How to change the transmission oil on the Honda PCX 150 scooter?

In this tutorial, you will see how to change the transmission oil on the Honda PCX 150 scooter, a very simple and quick operation. First, ensure the engine is completely cold, then locate the three bolts at the end of the casing and position a container underneath them. Next, remove the two inner bolts using a 12 mm socket, clean them of any dirt, and allow all the oil in the system to drain out. At this point, tighten the lower bolt and, using a pump or syringe, add new oil through the upper hole.

Watch the video!


by ScegliAuto

More videos