Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Reset the Service Light on the Piaggio MP3 250

Model: Piaggio Mp3 250
Part: Service warning light

Video tutorial

If the service light on your Piaggio MP3 250 dashboard comes on despite having performed the regular service, you must carry out the following manual reset procedure. First, position the scooter on its stand.

Then insert the key and turn on the ignition. At this point, press and hold the button located to the left of the rev counter and release it after a few seconds.

Next, press the button to the right of the speedometer once. As soon as the light changes, hold down the same button until the reset is complete.

Finally, turn off the ignition.


Updated on 14 July 2026 by ScegliAuto


Related tutorials

How to Replace the Transmission on a Piaggio MP3 250?
How to Replace the Transmission on a Piaggio MP3 250?
Mp3 250 To replace the transmission on the Piaggio MP3, loosen the bolts securing the protective cover located on the left side of the scooter, just below th…
How to Replace the Battery on the Piaggio MP3 250?
How to Replace the Battery on the Piaggio MP3 250?
Mp3 250 To replace the battery on the Piaggio MP3, open the under-seat compartment by turning the lock with the appropriate key to access the components insi…
How to Replace the Air Filter on the Piaggio MP3
How to Replace the Air Filter on the Piaggio MP3
Mp3 250 In this brief and simple guide, you will find the main instructions to remove and replace the air filter along with its housing on the Piaggio MP3 sc…

How to Replace the Front Headlight Bulbs on a KTM Duke 125?

Replacing the front headlight bulb on the KTM Duke 125, as shown in this tutorial, is an extremely simple and quick task. First, ensure that the key is not inserted, then using a Torx screwdriver, remove both the bolts and the rivets securing the front fairing and separate it from the handlebars. Next, remove the large rubber cap located at the back of the headlight, disconnect the power connector, and unlock the metal clip. Once the bulb is extracted, insert the replacement without touching the glass directly with your bare hands, and finally reassemble everything.

Watch the video!


by ScegliAuto

More videos