Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Coolant in the Piaggio Vespa GTS 300

Model: Piaggio Vespa Gts 300
Part: Antifreeze coolant

Video tutorial

Below are the steps to drain and subsequently refill the coolant on the Piaggio Vespa GTS 300 scooter. First, place the scooter on the centre stand and begin disconnecting the water pump casing pipe by loosening the clamp screw; allow the fluid to drain into a container for about ten minutes, as shown in the video.

At this point, unscrew the radiator cap located above the glove compartment, removing the plastic cap; then pour in the new coolant suitable for your radiator!


Updated on 19 September 2026 by ScegliAuto


Related tutorials

How to Top Up the Coolant in the Piaggio Vespa GTS 300
How to Top Up the Coolant in the Piaggio Vespa GTS 300
Vespa Gts 300 This guide shows how to check the coolant level in the Piaggio Vespa GTS 300 by following these simple and quick steps. First, place the scooter on i…
How to Replace the Coolant in a Piaggio Vespa GTS 300
How to Replace the Coolant in a Piaggio Vespa GTS 300
Vespa Gts 300 Today's instructions will show you how to drain and refill the engine coolant of the Piaggio Vespa GTS 300. First, place the scooter on its centre st…
How to Top Up the Coolant in the Piaggio Vespa GTS 300 Scooter
How to Top Up the Coolant in the Piaggio Vespa GTS 300 Scooter
Vespa Gts 300 In this tutorial, you will see how to top up the coolant in the Piaggio Vespa GTS 300 scooter, a very simple and quick operation. First, ensure that …

How to Assemble the Engine Block of the Husaberg FE 501

Here are the instructions to assemble the engine block of the Husaberg FE 501 enduro bike. First, assemble the engine transmission by installing the gear ratios and then the clutch assembly; after that, install the engine's thermal part by reassembling the crankshaft and then the cylinder head assembly (including piston, cylinder, and head), as shown in the video. At this point, install the stator and flywheel, as well as the electrical components of the engine, following the video tutorial to the end for reassembly!

Watch the video!


by ScegliAuto

More videos