Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Quadro
    3. : Qooder 400

How to Change the Engine Oil on the Quadro Qooder 400?

Model: Quadro Qooder 400
Part: Engine oil

Video tutorial

To change the engine oil on the Quadro Qooder 400, remove the panel located on the right side of the engine compartment, just behind the footrest area. Once the panel is removed, open the drain plug and tilt the bike to allow the oil to completely drain into a container.

In the same area, locate the oil filter, which needs to be removed and replaced with a new part; after the replacement, top up the oil through the vent located inside the under-seat compartment.


Updated on 22 June 2026 by ScegliAuto


Related tutorials

How do you replace the engine oil of the Piaggio BV 400?
How do you replace the engine oil of the Piaggio BV 400?
Bv 400 The replacement of the engine oil of the Piaggio BV 400 can be done by loosening the drain plug of the oil pan, located in the central lower part of …
How to Reset the Oil Light on the Suzuki Burgman 400
How to Reset the Oil Light on the Suzuki Burgman 400
Burgman 400 If you own a 2005 Suzuki Burgman 400 and want to learn how to manually reset the oil light, follow this guide and apply the steps described. First, e…
How to Replace the Engine Oil of the Piaggio BV 400?
How to Replace the Engine Oil of the Piaggio BV 400?
Bv 400 To replace the engine oil of the Piaggio BV 400, loosen the screws securing the oil drain plug located at the central lower part of the bike: once th…

How to remove the panels of the Peugeot Kisbee

In this short and simple guide, you will see how to remove the plastic panels of the Peugeot Kisbee scooter, following the instructions provided below. First, place your scooter on the centre stand and begin by lifting the rider's seat; then, unscrew the fixing screws found in the under-seat compartment and under the footboard, subsequently removing the panels as shown in the video. At this point, unscrew the screws of the footboard to remove it, then remove the front shield (disconnecting the electrical connectors as well); finally, reassemble everything by applying the reverse procedure!

Watch the video!


by ScegliAuto

More videos