Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you replace the crankshaft speed sensor of the RAM 1500?

Model: RAM 1500 D1, DC, DH, DR, DM, MK 3 - Years 2002-2009
Part: Crankshaft position sensor

In order to replace the crankshaft revolution sensor of the RAM 1500, you need to go and lift the car, so that you can access the components in the lower part of the engine compartment: here it will be possible to locate the crankshaft revolution sensor, immediately behind the exhaust manifold. It will be possible to remove it by disconnecting the connector connected to it: in this way the sensor can be replaced with a new spare part, which must be suitably connected and fixed to its housing in the lower part of the engine block.

Posted on 27 November 2022 by ScegliAuto

Video tutorial

Related tutorials

How to replace the crankshaft position sensor on the Dodge RAM 1500
How to replace the crankshaft position sensor on the Dodge RAM 1500
RAM 1500 (1994-2001 / BR, BE, MK 2) In today's video tutorial we will see how to remove and replace the crankshaft position sensor of the Dodge RAM 1500. First we open the engine hood a…
How do you replace the rear view mirror on the Dodge Ram 1500?
How do you replace the rear view mirror on the Dodge Ram 1500?
RAM 1500 (2009-2019 / DS, MK 4, DJ) In order to replace the Dodge Ram 1500 external rearview mirror, you must first remove the triangular plastic cover that is located in correspondence…
How to replace the Ram 1500 air filter
How to replace the Ram 1500 air filter
RAM 1500 (2019-2026 / MK 5, DT) If your Ram 1500's air filter is showing severe wear then it is time to replace it with a new model. Let's find out what the necessary steps are. Onc…

How to Replace the Cabin Fan Resistor on a BMW 3 Series

How to Replace the Cabin Fan Resistor on a BMW 3 Series. Open the door and remove the plastic cover under the dashboard on the right side. Use a trim tool to pry off the cover next to the dashboard. Get a screwdriver or a cordless drill, open the glove compartment, and unscrew the fastening screws around the perimeter with a screwdriver. Once this is done, pull out the glove compartment and disconnect the power cables. Remove the fan resistor from its housing, insert the new part into the filter holder, and reassemble all the components of the glove compartment as you disassembled them earlier.

Watch the video!


by ScegliAuto

More videos