|
Do it yourself
| |||
| ||||
How to change the rear brake pads of the Renault Scenic III
Model: Renault Scenic
Scenic 3, MK 3, MK III, Scenic III
- Years 2009-2015
In this video, we will see how to change the rear brake pads on the Renault Scenic III: we open the brake fluid reservoir cap, then lift the rear of the car and remove the rear wheels; remember to release the handbrake; if the car has an electronic handbrake, we need to put it in "maintenance mode"; unlock the brake caliper, then use a flat screwdriver to detach the caliper from its support, and remove the brake pads, then remove the anti-noise springs. Clean the support well with a wire brush. Push back the piston before installing the new brake pads; install the new anti-noise springs, then the new brake pads, then check the condition of the guide bushes and the rubber protection, in case they need to be replaced. We can put the caliper back in place, screwing in the bushes and closing with a torque wrench at 35 Nm. Repeat on the other side. If we have an electronic handbrake, we will need to reactivate it, after which we can put the wheels back on and lower the car.
Posted on 27 June 2025 by ScegliAuto
Video tutorial
Related tutorials
Renault Scenic
(2009-2015 /
Scenic 3, MK 3, MK III, Scenic III)
In this video tutorial, you will learn how to replace the brake pads on a Renault Scenic Xmod. First, lift the vehicle and remove the wheel. Then, us…
Renault Scenic
(2009-2015 /
Scenic 3, MK 3, MK III, Scenic III)
In this video we can see where the tools are located to change the wheels on the Renault Scenic III: we open the trunk and move the right rear seat. …
Renault Scenic
(2009-2015 /
Scenic 3, MK 3, MK III, Scenic III)
Let's see how to change the display on the instrument panel of a Renault Grand Scenic III from miles per hour (mph) to kilometers per hour (km/h). It…
Other guides you may be interested in
|
How to Check the Oil Level on a Jeep Renegade?
To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.397
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |