Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Front Headlight Bulb on a Renault Clio 4?

Model: Renault Clio Clio IV, MK 4, Clio 4 - Years 2012-2019
Part: Light bulb

To replace the front headlight bulb on a Renault Clio 4, open the bonnet to access the rear of the headlight corresponding to the bulb to be replaced. Detach the circular cover protecting the headlight to access its internal components. Disconnect the connector attached to the bulb, allowing you to remove the bulb from its housing. Connect the new bulb to the connector and insert it back into the headlight, sealing everything with the circular cover.

Updated on 9 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Headlight Bulb on a Renault Clio
How to Replace the Front Headlight Bulb on a Renault Clio
Renault Clio (2005-2013 / MK 3, Clio 3, Clio III) The following instructions will allow you to remove and replace the front headlight bulb on a Renault Clio. First, open the engine bonnet of the vehi…
How to Replace the Front Headlamp Bulb on the Renault Clio 4
How to Replace the Front Headlamp Bulb on the Renault Clio 4
Renault Clio (2012-2019 / Clio IV, MK 4, Clio 4) To replace the front headlamp bulb on the Renault Clio 4, open the bonnet and access the inside of the headlamp corresponding to the bulb to be repla…
How to Replace the Front Headlamp Bulbs on a Renault Clio
How to Replace the Front Headlamp Bulbs on a Renault Clio
Renault Clio (2012-2019 / Clio IV, MK 4, Clio 4) Learn how to replace the front headlamp bulbs on a Renault Clio. Open the bonnet (by pulling the lever located at the bottom right of the dashboard) …

Other guides you may be interested in

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos