Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Renault
    3. :
  3. Twingo
    4. : How to disassemble the starter motor of the Renault Twingo.

Renault Twingo - Video tutorial

Model: Renault Twingo Twingo 3, Twingo III - Years 2014-2023
Part: Starter motor
Operation: How to disassemble the starter motor of the Renault Twingo.

Below we will see the instructions that will allow us to disassemble and replace the starter motor of the Renault Twingo. First, we open the engine hood and start by removing the air filter box and intake ducts; then we will find the starter motor at the back, where we will unscrew the fixing screws and disconnect the electrical wiring to remove it, as shown in the video. At this point, we install the new original starter motor, making the electrical connections; finally, we reassemble all the previously disassembled components.


Posted on 1 October 2023 by ScegliAuto



How do you replace the starter motor of the Renault Twingo?
Renault Twingo (1993-2007 / Twingo 1) In order to replace the starter motor of the Renault Twingo, you need to loosen the screws that fix the device to its housing, in the lower part of t
Replacing the wiper motor on the Renault Twingo 1
Renault Twingo (1993-2007 / Twingo 1) In today's video tutorial we will see how to remove and replace the wiper motor on a Renault Twingo first series, following the instructions below. F
How to disassemble the front headlights in the Renault Twingo?
Renault Twingo (2014-2023 / Twingo 3, Twingo III) In this tutorial, we can see how to disassemble the front headlights in the Renault Twingo. First of all, make sure that the key is not inserted, the

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos