Do it yourself
Frequently asked questions about cars and motorcycles

How to perform a service reset on Renault Clio 4.

Model: Renault Clio MK 4, Clio 4, Clio IV - Years 2012-2019
Part: Warning light – error code

In this very short video guide today, we are shown the entire procedure necessary to reset the service light on a fourth generation Renault Clio, a model in production from 2012 to 2019. Let's start by inserting the electronic ignition key to turn on the vehicle's instrument panel. Then, we begin to press the arrow button on the end of the right lever until the display on the speedometer shows the message "perform revision" and we hold down the same button to enter it. Once this is done, to perform the service reset, we press and continue to hold down the arrow button on the revision message and the maintenance message, as shown in the video.

Posted on 19 November 2023 by ScegliAuto

Video tutorial

Related tutorials

Renault Clio (2019-2026 / Clio V, Clio 5) The procedure for resetting the service light, related to the car service, on a Renault Clio model 5, follows very simple and quick steps. First, we …
Renault Clio (2012-2019 / MK 4, Clio 4, Clio IV) Today we will explain how to reset the service light related to the car service on a Renault Clio model 4. To reset it, press the BC button, located …
Renault Clio (2012-2019 / MK 4, Clio 4, Clio IV) Resetting the service light on a Renault Clio model 4 is a simple operation that can be done independently. The first step is to turn on the instrume…

    Frequently Asked Questions

    • Clio 2005-2013 - What does the DF071 error message mean in the Renault Clio? Read answer
    • Clio 2005-2013 - What does the electrical fault warning light mean in the Renault Clio? Read answer
    • Clio 2012-2019 - What is the authentication code in a Clio and where is it located? Read answer

Replacing H7 Bulb in an Opel Meriva

Are the front headlight bulbs of your Opel Meriva out? Let's see how to proceed with the removal in this tutorial video. Open the bonnet and secure it, then remove the inspection caps from the headlights (at the back of the headlights) using a screwdriver or pliers. Disconnect the bulb holders from the headlight and disconnect the relevant power connectors. Replace the damaged bulbs with new ones (same size and voltage). After replacing the bulbs, refit the bulb holder into the headlight housing. Finally, close the back of the headlights with the inspection caps. Test the correct functioning of the lights by turning on the ignition.

Watch the video!


by ScegliAuto

More videos