Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Where to find the chassis number and engine number of the Roewe 550 - MG 550?

Model: Roewe 550 MK 1 - Years 2008-2014
Part: Checks and maintenance

Let's see in this short and simple guide where to find the chassis number and the engine number of the MG 550, as well as the Roewe 550. First, let's open the hood of our car and start locating the chassis number; we can find it printed on the right front suspension pillar (left side from the engine compartment), as shown in the video. On the other hand, we find the engine number on the block, located near the exhaust manifold; it is important to verify that both numbers match those listed in the manual of our vehicle.

Posted on 3 July 2023 by ScegliAuto

Video tutorial

Related tutorials

Where are the fuses of the Roewe 550?
Where are the fuses of the Roewe 550?
Roewe 550 (2008-2014 / MK 1) .. in the Roewe 550. This car is also known as the MG 550, so let's not be fooled by the title of the video: it is the exact same model. As we can see,.. …
How do you replace the Roewe 550 headlight?
How do you replace the Roewe 550 headlight?
Roewe 550 (2008-2014 / MK 1) In order to replace the front headlight of the Roewe 550 you have to go and open the bonnet, so that you can loosen the screws that fix the front bum…

How to Change the Diesel Filter on a Renault Captur 1.5 dCi

The diesel filter on the Renault Captur is always of the immersion type, but instead of being located at the top of the engine bay, it is positioned lower, inside the front right wheel arch (passenger side), practically under the headlamp. To replace it, it is advisable to lift the vehicle, remove the front right wheel and the corresponding inner lining to access the filter location. Unscrew the fastening nuts of the support clamp to extract it from its housing and disconnect the connector and pipes. At this point, unscrew the fixing screws of the cap, remove the old filter and insert the new one, also replacing the O-ring seals, and then reverse the steps for installation. Before starting the engine, turn the ignition on and off several times to allow the filter to fill.

Watch the video!


by ScegliAuto

More videos