Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Kia
    3. :
  3. Cee D
    4. : How to replace the spark plugs on the Kia Cee D

Kia Cee D - Video tutorial

Model: Kia Cee D MK 1 - Years 2006-2012
Part: Spark plugs
Operation: How to replace the spark plugs on the Kia Cee D

As a first operation, unhook the hood from the special lever to then be able to lift and hold it with the appropriate rod, then remove the upper rear cover of the engine, where the upper parts of the spark plugs are located, in fact once the cover has been removed you can unhook the pins from the coils that feed the spark plugs in the lower part of the cylinder where the coils are housed, then with a socket wrench you can unscrew the spark plugs and pull them up, if your key is magnetized, otherwise it will be necessary to use a pliers with a long spout, and that's it.


Posted on 29 September 2023 by ScegliAuto



Removing the Kia Cee'd spark plugs
Kia Cee D (2006-2012 / MK 1) In this short video we will see the position of the spark plugs of a Kia Cee'd, so that they can be removed. First of all, we open the bonnet of the
Instructions for replacing the glow plugs on the Kia Cee'd 1.4 CRDI
Kia Cee D (2006-2012 / MK 1) In this short guide we will see the steps that will allow us to disassemble and replace the pre-heating glow plugs on the Kia Cee'D, with 1.4 CRDI en
How to replace the key battery of a Kia Ceed
Kia Cee D (2006-2012 / MK 1) Let's start by pressing and holding the button located on the upper side of the electric key of our Kia Cee D, going to open the physical key. After

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos