Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Wiring and Resistor (Regulator) Replacement

Model: Saab 9 5 Ys3e, MK 1 - Years 1997-2010
Part: Blower motor

Open the front bonnet and ensure it is securely supported. Remove the wiper blade and take off the plastic cover located just below the windscreen and the cover of the wiper motor. Next, remove the fixing pins of the wiper motor, the one connected to the wiper arm, and the corresponding electrical connector to remove it. Unscrew the fixing pins of the other plastic cover and remove it. Unscrew the three fixing pins of the wiper support bracket and take it off. Release the cable clips and unscrew the other fixing pins of the cover on the fan. At this point, you can extract the electrofan assembly from its location. Proceed with the replacement of the wiring and the corresponding regulator, then install the fan by reversing the disassembly steps.

Updated on 4 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of Crankshaft Position Sensor
Replacement of Crankshaft Position Sensor
Saab 9 5 (1997-2010 / Ys3e, MK 1) If your Saab's engine has difficulty starting when hot, it is likely due to the crankshaft position sensor. The replacement is not particularly diffi…
Replacing the Ignition Cassette
Replacing the Ignition Cassette
Saab 9 5 (1997-2010 / Ys3e, MK 1) This tutorial video demonstrates how to replace the ignition cassette on a Saab 9-5. The operation takes very little time. The injection cassette is …
Replacing the Rocker Cover Gasket
Replacing the Rocker Cover Gasket
Saab 9 5 (1997-2010 / Ys3e, MK 1) After thoroughly cleaning the gasket seating on both the cover and cylinder head sides, apply gasket sealant in the grooved areas, place the two gask…

How to Replace the Remote Battery for the Volvo XC40?

In this tutorial, you will see how to replace the battery in the remote for the Volvo XC40, a very simple and quick operation. For this, you will need a replacement battery of type CR2032 and possibly a small flathead screwdriver. First, remove the front cover by pressing the button on the metal ring, then locate the second button, press it as well, and remove the opposite cover. Next, open the circular cap, take out the old battery, and insert the new one in the opposite direction. Finally, reassemble everything.

Watch the video!


by ScegliAuto

More videos