Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Disassembly of the rear light of the Seat Ateca.

Model: Seat Ateca MK 1 - Years 2016-2025
Part: Tail light

Today's steps will show us how to disassemble and replace the rear taillight and its bulbs of the Seat Ateca. First, we open the rear hatch of the trunk and start removing the side panel to access the rear part of the taillight; then we unscrew the plastic screw to remove the rear light from the outside, disconnecting the electrical connector of the lights, as shown in the video. At this point, we separate the bulb holder from the light fixture if we want to replace any faulty bulbs, replacing either the entire taillight; then we reassemble the rear light!

Posted on 26 August 2024 by ScegliAuto

Video tutorial

Related tutorials

How to remove the rear bumper of the Seat Ateca.
How to remove the rear bumper of the Seat Ateca.
Seat Ateca (2016-2025 / MK 1) Today we will explain how to remove the rear bumper of the Seat Ateca. To remove the bumper, we first need to take out the rear lights. Let's open th…
How to remove the door panel of the Seat Ateca
How to remove the door panel of the Seat Ateca
Seat Ateca (2016-2025 / MK 1) Removing the rear door panel of the Seat Ateca is a very simple and quick operation to perform independently, also thanks to our short and instructiv…
Replacing the Key Battery on the Seat Ateca
Replacing the Key Battery on the Seat Ateca
Seat Ateca (2016-2025 / MK 1) Today, let’s look at the main instructions for disassembling and replacing the battery of the remote key for the Seat Ateca. First, take your key and…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos