Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Centre Instrument Cluster from a Seat Leon

Model: Seat Leon 1P - Years 2005-2013
Part: Dashboard

In today's tutorial video, you will see how to remove the centre instrument cluster from a second series Seat Leon. First, get inside the car and remove the radio by prying at the sides of the plastic trim. Pull it forward and disconnect the electrical connector at the back along with any antenna cable. Next, unscrew the Torx screws found at the top and use a lever to remove the upper part of the instrument cluster, also taking out the air vents. Finally, disconnect the electrical connectors located at the back!

Updated on 6 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Reset the Service Light on the Seat Leon?
How to Reset the Service Light on the Seat Leon?
Seat Leon (2012-2019 / MK 3, 5F) From the instrument cluster of the Seat Leon, you can completely clear the Service light by holding down the 0.0/SET button located in the central lo…
How to reset the tire pressure sensor on the Seat Leon 2016
How to reset the tire pressure sensor on the Seat Leon 2016
Seat Leon (2012-2019 / MK 3, 5F) If the tire warning light continues to appear on the instrument panel of your 2016 Seat Leon despite the absence of a puncture or pressure loss, then…
How to Reset the Service Light on a 2014 Seat Leon
How to Reset the Service Light on a 2014 Seat Leon
Seat Leon (2005-2013 / 1P) In this mini guide dedicated to your Seat Leon 1P (year 2007), discover how to reset the maintenance light safely and independently. First, enter the…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos