Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installation of Aux Adapter Kit and Removal of Car Radio

Model: Skoda Octavia 1Z, MK 2 - Years: 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012
Part: Accessory kit

See other generations:
Video tutorial

To install the Aux adapter, you must first remove the original car radio as explained below. Start by removing the plastic fascia surrounding the radio and climate control buttons, pulling it from the bottom (the fascia is simply clipped in). Next, unscrew the four fixing screws of the radio located at the corners, pull it out from its housing, disconnecting the plugs attached to it: locate the blue area of the connector.

Then connect the Aux adapter wiring to the three free positions of the blue connector according to the wiring diagram shown in the figure, while the other ends of the wiring can be soldered to a 3.5 mm audio socket to be installed at the desired location in the cabin (for example, on a free button below the climate control buttons).

Finally, reposition the radio and the corresponding fascia.


Updated on 4 February 2026 by ScegliAuto


Related tutorials

Replacing Original Car Radio
Replacing Original Car Radio
Skoda Octavia (1996-2004 / MK 1, 1U) Remove the old car radio, then take out the screws from the dashboard panel that needs to be replaced with a new one suitable for housing the new rad…
Removing the Original Car Radio
Removing the Original Car Radio
Skoda Octavia (2004-2012 / 1Z, MK 2) Using a small flathead screwdriver, remove the 4 caps located at the corners of the car radio and unscrew the 4 Torx screws (T25) securing the radio.…
Car Radio Removal Instructions
Car Radio Removal Instructions
Skoda Octavia (2004-2012 / 1Z, MK 2) Removing the original car radio does not require special tools but demands precision in removing the surrounding trim: use a plastic lever to detach …

How to Open the Hood of the BMW X3

Today, you will learn how to open and close the hood of the BMW X3. To perform this simple operation, lift the hood release lever located next to the door seal on the driver’s side. After pulling the lever, you will notice that the hood will lift slightly. Position yourself in front of the hood and lift it after moving the internal lever from left to right. To keep the hood secure during maintenance, use the side support rod. To close the hood, simply let it fall back into place.

Watch the video!


by ScegliAuto

More videos