Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Open the Bonnet of a Smart Roadster?

Model: Smart Smart Roadster, 452 - Years 2003-2005
Part: Body

To open the front bonnet of a Smart Roadster, access the cabin and locate the lever just below the glove compartment on the passenger side. Once this lever is pulled, the bonnet will lift slightly: to fully open it, remove the catch at the front of the bonnet. When this catch is removed, you can open the bonnet to access the internal part of the boot. To close it, ensure that the lever at the front of the bonnet clicks into place.

Updated on 14 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Repair the Hood of a Smart Roadster?
How to Repair the Hood of a Smart Roadster?
Smart (2003-2005 / Roadster, 452) To repair the hood of a Smart Roadster, you need to fully close it so that the fabric covering can be removed from the respective snap pins. Next, th…
How to Replace the Roof of the Smart Roadster
How to Replace the Roof of the Smart Roadster
Smart (2003-2005 / Roadster, 452) To replace the roof of the Smart Roadster, open the bonnet and unscrew the fixing screws of the internal compartment to access the battery underneath…
How to Replace the Front Headlight of the Smart Roadster?
How to Replace the Front Headlight of the Smart Roadster?
Smart (2003-2005 / Roadster, 452) To replace the front headlight of the Smart Roadster, open the bonnet and loosen the bolts securing the front headlight cover, located at the top and…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos