Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Brake Pads

Model: Subaru Outback MK 2, BH, BE - Years 1999-2003
Part: Brake pads

Remove the wheel and gently detach the caliper by removing the two retaining clips with two large screwdrivers or the appropriate tools. Unscrew the two caliper pins and remove the worn pads, replacing them with two new ones of the same type. Clean the pads and the entire mechanical assembly thoroughly using compressed air and a deoxidising spray. Refit the bracket, cleaning and lubricating the retaining springs, then tighten them. Reattach the caliper, ensuring the various clips are positioned correctly. The pad with the electrical contacts should be mounted towards the inside, paying attention to the direction of travel. Realign the piston by pushing it inward and check the pads' adherence to the disc. Perform the same operation on the other brake.

Updated on 4 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing Front Discs and Pads
Replacing Front Discs and Pads
Subaru Outback (2009-2014 / MK 4, BM, BR) Once the vehicle is raised on a lift or supported by appropriate axle stands, remove the front wheel. Leverage between the disc and pads to retract t…
Replacing the Front Brake Pads on the Subaru Outback MK4
Replacing the Front Brake Pads on the Subaru Outback MK4
Subaru Outback (2009-2014 / MK 4, BM, BR) In this video, learn how to remove and replace the front brake discs and pads on the fourth series Subaru Outback, following the instructions below. …
Replacing the Front Brake Pads on a Subaru Outback
Replacing the Front Brake Pads on a Subaru Outback
Subaru Outback (2014-2019 / BS, MK 5) This video tutorial shows how to replace the old brake pads on a Subaru Outback, model produced from 2014 to 2019. To start, lift the car and remove …

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos