Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Gear Oil on a Sym Joymax 250i

Model: Sym Joymax 250
Part: Transmission fluid

This video is currently unavailable

In this video tutorial, you will learn how to change the transmission oil on a Sym Joymax 250i scooter by following these simple steps. First, position the scooter on its centre stand and use a ratchet Torx key to remove the oil drain screw from the gearbox, as shown in the video; allow it to drain into a container for about ten minutes.

Next, open the filler screw located at the top of the transmission casing; now fill the casing with the correct new gearbox oil: to do this, use a syringe!


Updated on 4 May 2026 by ScegliAuto


Related tutorials

How to Change the Engine Oil on a Sym Joymax 250i
How to Change the Engine Oil on a Sym Joymax 250i
Joymax 250 In today's tutorial, learn how to perform the routine maintenance oil change on a Sym Joymax 250i scooter. First, position your scooter on the centre…
How to Replace the Air Filter on a Sym Joymax 250i?
How to Replace the Air Filter on a Sym Joymax 250i?
Joymax 250 To replace the air filter on the Sym Joymax 250i, loosen the bolts securing the cover of the casing located near the rear wheel, just above the trans…
How to Replace the Coolant on a Sym Joymax 250i
How to Replace the Coolant on a Sym Joymax 250i
Joymax 250 This guide will show you the steps to bleed and top up the coolant on the Sym Joymax 250i scooter. First, place your scooter on the centre stand and …

How to Change the Engine Oil in a Suzuki DR 350?

In this tutorial, you will see how to change the engine oil in a Suzuki DR 350, a very simple and quick operation. First, wait until the engine is cold enough, then remove the protective frame located at the bottom. Next, position a container underneath the bike, disconnect the indicated hose, and let all the oil in the system drain out. Then, open the filter housing by unscrewing the three bolts with an 8mm spanner, remove the old filter, and insert the replacement. At this point, you can reassemble everything and pour in the new oil through the designated hole.

Watch the video!


by ScegliAuto

More videos