Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Remove the round plastic cover from the fairing that covers the clutch by unscrewing the four screws. You will now find another cover with more screws: repeat the process. Slide out the clutch discs using a flathead screwdriver and clean them from old lubricant. HYDRAULIC CLUTCH BLEEDING: to bleed the air, remove the cover of the clutch pump on the handlebars. Connect the appropriate vacuum machine to the bleed nipple (5) of the clutch pump cylinder on the engine and operate it. Continue until only oil comes out of the nipple, with no more air. Tighten the nipple and disconnect the vacuum machine. During the operation, ensure that the level in the clutch pump reservoir is always sufficient to prevent the pump from drawing in air. If necessary, top up with DOT4 brake fluid.

Updated on 28 March 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you dismantle the engine of the TM Racing SMR 450 F?
How do you dismantle the engine of the TM Racing SMR 450 F?
Smr 450 F In order to disassemble the engine of the TM Racing SMR 450 F, you need to loosen the screws that fix the piece to its housing located in the center …
How do you replace the motor oil of the TM Racing SMR 450?
How do you replace the motor oil of the TM Racing SMR 450?
Smr 450 F In order to replace the motor oil of the TM Racing SMR 450, you need to loosen the oil tank drain plug, which is located at the bottom of the vehicle…
How to Service the TM Racing SMR 450
How to Service the TM Racing SMR 450
Smr 450 F In this video tutorial, learn how to perform the routine oil change service on a TM Racing SMR 450. First, remove the skid plate by unscrewing the se…

How to replace the coolant in the BMW S1000 R

Today, we will see in this video tutorial how to bleed and replace the coolant in the BMW S1000 R motorcycle. First, place your motorcycle on a stand and start unscrewing the bleed screw located on the water pump casing, found at the bottom right; let the fluid drain into a container for about ten minutes. Now, unscrew the radiator cap and top up with the new coolant, the correct type for your radiator; fill it to the maximum level mark, starting the engine to circulate the fluid!

Watch the video!


by ScegliAuto

More videos