Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To replace the exhaust on a Tm Racing SMR 125, you need to loosen the bolts indicated in the video to remove the seat, which must first be pulled back and then lifted. After removing these screws, you will also be able to slide off the side panel that covers the exhaust. When the screws supporting the exhaust are also loosened, it can be removed by pulling it. You will need to remove the rubber from the old exhaust and fit it onto the new exhaust, along with the silent block. At this point, insert the new exhaust into the expansion chamber and finally fit all the screws and parts previously removed.

Updated on 20 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the exhaust pipe of the TM Racing SMR 125?
How do you replace the exhaust pipe of the TM Racing SMR 125?
Smr 125 To replace the exhaust pipe of the TM Racing SMR 125, you need to loosen the screws that hold the side panel on the right side of the motorcycle: onc…
How to Replace the Exhaust on a TM Racing SMR 125
How to Replace the Exhaust on a TM Racing SMR 125
Smr 125 On the TM Racing SMR 125, you can replace the exhaust by loosening the bolts that secure the side panel near the rear mudguard. Once the side panel i…
How do you replace the exhaust pipe of the TM Racing SMR 125?
How do you replace the exhaust pipe of the TM Racing SMR 125?
Smr 125 The muffler of the TM Racing SMR 125 can be replaced by loosening the screws that secure the exhaust terminal to its housing, located on the right si…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos