Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Toyota
  4. :
  5. Yaris Sedan
  6. : How to replace the drip molding on the Toyota Yaris Sedan

Toyota Yaris Sedan - Video tutorial

Model: Toyota Yaris Sedan Xp90 - Years 2005-2013
Part: Bodywork
Operation: How to replace the drip molding on the Toyota Yaris Sedan

If we want to replace the rubber molding of the drip on the roof of the car we must follow the instructions below and refer to the video. Over the years, atmospheric agents and in particular the sun tend to age the rubber of the drips which tends to break. Then proceed to detach the drip tray from its seat, then carefully clean the seat on the bodywork, take the new profile that we would have purchased after market and place it on the seat starting from the rear of the car and to release it, press with your fingers. Then repeat the same procedure for the other drip tray.


Posted on 11 May 2024 by ScegliAuto

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos