Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Toyota
  4. :
  5. Sienta
  6. : How to disassemble the car radio of the Toyota Sienta

Toyota Sienta - Video tutorial

Model: Toyota Sienta Npc80 - Years 2003-2015
Part: Car stereo
Operation: How to disassemble the car radio of the Toyota Sienta

Let's see in this guide how to disassemble and replace the Toyota Sienta car stereo, following the instructions below. First of all, let's get on board the car and start removing the plastic cover that we find on the base of the gear lever; then we remove both air conditioning knobs, as shown in the video. At this point we remove the climate controls and the central plastic cover, unscrewing the screws and levering the sides with something thin; then we remove the entire car radio, disconnecting the electrical wiring located on the back of the radio!


Posted on 27 July 2022 by ScegliAuto

Other guides that may interest you

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos