Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Spoiler on the Toyota Rav4

Model: Toyota Rav 4 Xa30, MK 3 - Years: 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013
Part: Body

See other generations:
Video tutorial

If you need to remove the rear spoiler on this vehicle model due to damage, follow the instructions below for proper operation. Obtain a compatible replacement for the vehicle model.

Open the tailgate and detach the upper plastic trim inside it. Underneath, you will find the screws securing the spoiler, which you will need to remove. Disconnect the connector for the third brake light, and at this point, you can remove the old spoiler and position the new one. Reconnect the third brake light connector and screw in the securing screws.

Finally, reposition the plastic finishing panel.


Updated on 26 July 2026 by ScegliAuto


Related tutorials

How to Remove the Instrument Cluster from a Toyota RAV4
How to Remove the Instrument Cluster from a Toyota RAV4
Toyota Rav 4 (2019-2026 / MK 5, Xa50) Thanks to the procedure described in this guide, you will be able to remove the instrument cluster from your Toyota RAV4 (latest model) in just a few…
How to Reset the Tyre Warning Light on the Toyota RAV4
How to Reset the Tyre Warning Light on the Toyota RAV4
Toyota Rav 4 (2013-2018 / Xa40, MK 4) To manually reset the tyre warning light on your Toyota RAV4 fourth generation (2013-2018), follow these simple steps. First, enter the cabin and tur…
Where to Find the OBD Port of the 2009 Toyota RAV4
Where to Find the OBD Port of the 2009 Toyota RAV4
Toyota Rav 4 (2006-2013 / Xa30, MK 3) Locating the OBD port of your 2009 Toyota RAV4 is very simple, and with the following procedure, you will have no difficulty. First, ensure your car …

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos