Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Rear Seats from a Toyota Corolla

Model: Toyota Corolla MK 3 - Years 2006-2013
Part: Seat

We will briefly go through the steps to remove the rear seats from the Toyota Corolla, following the instructions below. First, open the rear doors and begin by removing the seat bench by pulling it upwards. Then unscrew the fixing screws found at the base of the seatbacks to remove them as well, as illustrated in the video. At this point, clean or replace the seats if necessary; reassemble the rear seats by first reinstalling the seatbacks and then the seat bench, following the video tutorial to the end!

Updated on 20 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Fold Down the Rear Seats of a Toyota Corolla
How to Fold Down the Rear Seats of a Toyota Corolla
Toyota Corolla (2006-2013 / MK 3) Before you begin, open the rear doors of your Toyota Corolla. Start by pulling upwards on the hooks located at the upper corners of the rear seats to…
How to Remove the Rear Seats of the Toyota Corolla
How to Remove the Rear Seats of the Toyota Corolla
Toyota Corolla (2019-2026 / MK 5, E210) Follow these steps to remove and replace the rear seats of the Toyota Corolla. First, open the rear doors and lower all the seat backs. Next, unscrew…
How to remove the rear seats of the Toyota Corolla.
How to remove the rear seats of the Toyota Corolla.
Toyota Corolla (2019-2026 / MK 5, E210) In this guide, we will see the instructions that will allow us to disassemble and replace the rear seats of the Toyota Corolla. First, let's open the…

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos