Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the front brake pads of the Triumph Street Twin

Model: Triumph Street Twin
Part: Brake pads

Video tutorial

In a few simple steps, we will see the process of disassembling and replacing the front brake pads of the Triumph Street Twin motorcycle. First, we put the motorcycle on the stand and start unscrewing the fastening screws of the front brake caliper, moving away the speedometer cable; we remove the caliper from the disc, applying pressure on the caliper piston to remove the old pads, as shown in the video.

At this point, we clean the caliper from any residual dirt, installing the new original brake pads; finally, we reassemble the brake caliper on the disc!


Posted on 27 August 2025 by ScegliAuto


Related tutorials

How to Replace the Front Brake Pads of the Triumph Street Twin
How to Replace the Front Brake Pads of the Triumph Street Twin
Street Twin In this brief and simple guide, see how to remove and replace the front brake pads of the Triumph Street Twin in easy and quick steps. First, place t…
How to Remove the Front Headlight on a Triumph Street Twin
How to Remove the Front Headlight on a Triumph Street Twin
Street Twin Before you start, position your Triumph Street Twin on a paddock stand. Begin by unscrewing and removing the screws that secure the front headlight t…
How to replace the rear suspensions of the Triumph Street Twin
How to replace the rear suspensions of the Triumph Street Twin
Street Twin Today we will discover the instructions that will allow us to disassemble and replace the rear suspensions of the Triumph Street Twin motorcycle, thu…

Vespa Immobiliser: How to Transfer the Chip from the Old Key

In the case shown in the video, the new keys are not recognised by the ECU: the Vespa starts but does not run (thus the immobiliser is active). The solution shown in the video involves locating the immobiliser chip in the old key (the one recognised by the ECU). Open the cover on the key (only red master keys or some blue ones), remove the chip (which is a small black cylinder or rectangle), insert it into the new key in place of the new one, and try to start. Now the key will work. If the master key is red, it will definitely work. If it is blue, it might work: you need to cut the silicone; this is possible but a delicate operation. If it is a black clone key, then it is a system that does not work.

Watch the video!


by ScegliAuto

More videos