Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install Heated Grips on a Triumph Street Triple 765R?

Model: Triumph Street Triple 765r
Part:

Video tutorial

To install heated grips on a Triumph Street Triple 765R, first remove the mirrors by loosening the corresponding bolts, then take off the old grips. You will also need to remove the seat by unscrewing the fixing bolts.

Once the seat is removed, disconnect the tank by loosening the Allen bolts located under the handlebars. Pass the cables through, which will later connect to the new grips.

Once the cables are through and exit the holes, connect them to the new grips, which can then be fitted along with the previously removed mirrors.


Updated on 20 April 2026 by ScegliAuto


Related tutorials

How to Replace the Headlamp of the Triumph Street Triple 765R?
How to Replace the Headlamp of the Triumph Street Triple 765R?
Street Triple 765r To replace the headlamp of the Triumph Street Triple 765R, you need to loosen all the screws that secure the headlight unit to its housing: these scr…
How do you replace the exhaust on the Triumph Street Triple 765?
How do you replace the exhaust on the Triumph Street Triple 765?
Street Triple 765r The replacement of the exhaust installed on the Triumph Street Triple 765 can be carried out by loosening the screws that secure the end can to its h…
How to Replace the Rear Brake Pads on the Triumph Street Triple 765 RS?
How to Replace the Rear Brake Pads on the Triumph Street Triple 765 RS?
Street Triple 765r In this tutorial, see how to replace the rear brake pads on the Triumph Street Triple 765 RS, a very simple and quick operation. Start by positioning…

How to Change the Transmission Oil in the Honda SH 150i Scooter?

Changing the transmission oil in the Honda SH 150i scooter, as shown in this tutorial, is an extremely simple and quick operation. First, wait until the engine is cool enough, then locate the three bolts at the rear of the casing and position a container underneath them. Next, use a 12mm socket to remove the two inner bolts, allowing all the oil in the system to drain out, and then tighten the lower bolt. At this point, simply pour in the new oil through the upper hole, using a syringe and a thin tube if necessary.

Watch the video!


by ScegliAuto

More videos