Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you disassemble the TM Racing KZ10C engine?

Model: (Various brands) Various
Part: Engine

Video tutorial

To disassemble the TM Racing KZ10C engine, you need to remove it from its housing by loosening the screws that secure the engine to the center of the chassis and disconnecting the cables and connectors. Once these screws have been loosened, you can loosen the ones that secure the cylinder to the top of the engine block.

The piston inside can be freed from the connecting rod by removing the ring and corresponding pin. At this point, you can access the crankshaft, replace the necessary parts, and close the casing again.


Posted on 31 October 2025 by ScegliAuto


Related tutorials

How to Dismantle the TM Racing KZ10C Engine?
How to Dismantle the TM Racing KZ10C Engine?
(Various brands) Various To dismantle the TM Racing KZ10C engine, first remove it from its housing by unscrewing the screws that secure it to the respective supports and disc…
How do you replace the piston of the TM Racing KZ10C engine?
How do you replace the piston of the TM Racing KZ10C engine?
(Various brands) Various To replace the piston of the TM Racing KZ10C engine, you need to loosen the screws that secure the cylinder to the top of the engine block: before do…
How to Dismantle the TM Racing Engine?
How to Dismantle the TM Racing Engine?
(Various brands) Various To dismantle the TM Racing engine, loosen the screws securing the two side casings of the engine block and remove them completely. Then, proceed to d…

How to Change the Engine Oil on a Kawasaki Ninja 650?

To change the engine oil on a Kawasaki Ninja 650, it is important to start by warming up the engine for a few minutes, so the oil becomes more fluid and easier to drain. Position the bike on a stable stand, such as a centre or side stand. Locate the oil drain plug at the bottom of the engine and place a container underneath to collect the used fluid. Carefully unscrew the plug, allowing the old oil to drain completely. Once emptied, screw the plug back in, ensuring it is tight to avoid leaks. Proceed to add new oil through the top opening of the reservoir, following the type and quantity recommended by the manufacturer. After filling, start the engine to circulate the fresh oil, then turn it off and check the level, adding more if necessary to reach the optimal level.

Watch the video!


by ScegliAuto

More videos