Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Brake Lever on a Motorcycle.

Model: (Various brands) Various

Below, we describe how to replace the brake lever on a motorcycle. First, gather a 10 mm spanner and a small screwdriver. Use the spanner to unscrew the nut located just below the brake lever, and with the small screwdriver, hold the bolt from above. Then completely unscrew the fixing bolt from above. At this point, the lever can be extracted, and you can mount the new one by positioning it in the housing and reinserting the bolt from above, tightening it with the supplied 10 mm nut.

Updated on 20 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Clutch Lever on a KTM 125 Motorcycle
How to Replace the Clutch Lever on a KTM 125 Motorcycle
(Various brands) Various In this short video, you will see how to replace the left lever (which represents the clutch) on the KTM 125 motorcycle. First, use pliers to unscrew…
How to Replace the Brake Lever on a Motorcycle or Scooter
How to Replace the Brake Lever on a Motorcycle or Scooter
(Various brands) Various Follow these steps to replace the brake lever: this method applies to all types of motorcycles or scooters. Start by removing the lower screw of the …
How to Overhaul the Brake Pump
How to Overhaul the Brake Pump
(Various brands) Various Here’s how to overhaul the brake pump: first, be very careful when handling brake fluid as it can corrode paint. To proceed, disconnect the brake lin…

    Frequently Asked Questions

    • Vari - Opinions on Nankang AW-6 Cross Season tyres Read answer
    • Vari - How does the BRC LPG switch work? Read answer
    • Vari - What problems can a Piaggio MP3 give? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos