Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Engine Mounts

Model: (Various brands) Various
Part: Bushings

The mounts are responsible for keeping the engine in position and absorbing the resulting vibrations. Although their number depends on the type of engine, these should be checked and replaced from time to time. Let's look at the types of engines and how many mounts they have: - The longitudinal engine has three mounts, one on each side. - The transverse engine has two holding mounts and one stabilising mount. The replacement procedures are similar for both models; it is important to remember to lift the engine before replacing the mounts to avoid load on the support. To remove them, loosen all the fastening elements and ensure the mount is unloaded. Then, remove them and clean the housing of each mount. Finally, install the new mounts.

Updated on 2 August 2026 by ScegliAuto

Video tutorial

Related tutorials

Removing Engine Mounts
Removing Engine Mounts
(Various brands) Various In this video tutorial, you will see the main instructions for removing the engine mounts of a generic car. The engine mount serves to dampen the exc…
Removing Universal Car Antenna
Removing Universal Car Antenna
(Various brands) Various Remove the universal antenna from your car. Take off the interior light or the trim panel at the rear of the car (depending on whether the antenna is…
How to remove the Telepass holder from the car windshield
How to remove the Telepass holder from the car windshield
(Various brands) Various The Telepass holder is usually attached to the car windshield in order to ensure that the Telepass works immediately when passing through toll gates.…

Other guides you may be interested in

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos