Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace the Rear Wiper Blade on a Car

Model: (Various brands) Various
Part: Windshield wipers

When you notice that the rear wiper blade is noisy and not cleaning properly, it is likely the arm that needs replacing rather than the blade itself. Over time, the arm tends to weaken, particularly the spring inside it. To replace it, remove the plastic cap covering the locking pin on the tailgate. Once done, pull out the arm, using a puller if necessary, taking care not to damage the thread of the fixing shaft or any incorporated nozzle, then proceed to fit the new one.

Updated on 16 August 2026 by ScegliAuto

Video tutorial

Related tutorials

(Various brands) Various In this video, you will learn how to replace the front headlight of a car, in this case, a Toyota Aygo. As the first step, with the vehicle off, unsc…
(Various brands) Various Replacing the windshield wiper blades of a car follows the same steps on almost all vehicles of both new and old generations. To replace the blades, …
(Various brands) Various To correctly activate and deactivate the wipers on your car, locate the controls, usually found on the multifunction lever just behind the steering w…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos