Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Front Bulb on Volkswagen Polo 9n

Model: Volkswagen Polo MK IV, Polo IV, Polo 4, MK 4, 9N - Years 2001-2009
Part: Headlight bulb

Video tutorial
Detailed instructions - Open the bonnet and insert the support rod. Remove the round cover behind the headlamp by pulling it off by hand. Disconnect the connector and unlock the plastic circular clip: to do this, rotate it slightly anti-clockwise to release it from the clips and create space to extract the bulb. For reassembly, proceed in reverse: insert the new bulb and secure the clip by turning it clockwise. Reconnect the connector and refit the rear cover of the dipped beam. Start the car and check.

Updated on 3 April 2026 by ScegliAuto


Related tutorials

How to Replace the Front Headlight Bulb of a Volkswagen Polo?
How to Replace the Front Headlight Bulb of a Volkswagen Polo?
Volkswagen Polo (2001-2009 / MK IV, Polo IV, Polo 4, MK 4, 9N) Good morning! Today, replace the front headlight bulb of your Volkswagen Polo. Start by opening the front bonnet. Next, unscrew and remove the rear c…
Replacement of the front fog light bulb of the Volkswagen Polo
Replacement of the front fog light bulb of the Volkswagen Polo
Volkswagen Polo (2001-2009 / MK IV, Polo IV, Polo 4, MK 4, 9N) Today's information will show us how to disassemble and replace the front fog light bulb of the Volkswagen Polo. First, let's move to the front and s…
How to Replace the Rear Light Bulb on a Volkswagen Polo
How to Replace the Rear Light Bulb on a Volkswagen Polo
Volkswagen Polo (2009-2017 / Polo 5, Polo V, MK 5, MK V, 6R) To replace the rear light bulb on a Volkswagen Polo, open the boot and lift the side carpet in line with the light. Underneath, you will find a pin t…

How to reset the tyre pressure warning light on the Citroën DS4?

The tyre pressure warning light on the Citroën DS4 can be reset by inflating the tyres until they reach the corresponding pressure value, which is indicated on the sticker attached to the driver's door pillar. Once all tyres are at this value, turn on the ignition by inserting the key into the ignition switch; this should make the warning light disappear from the dashboard. If it does not reset, start the engine and drive to allow the sensors to read the new values.

Watch the video!


by ScegliAuto

More videos