Do it yourself
Frequently asked questions about cars and motorcycles

How to Install the Rear Camera on the Volkswagen Golf 7?

Model: Volkswagen Golf MK 7, Golf 7, Golf VII - Years: 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019
Part: Parking sensors

See other generations:
Video tutorial

This video illustrates and verbally describes the procedure for installing the rear camera on the Volkswagen Golf 7. Specialist websites selling this accessory offer various models; in this case, the choice fell on the model integrated into the Volkswagen badge located on the tailgate.

Remove the original from the inside by taking off the plastic trim and replace it with the new one mentioned.

The electrical connection cable must be routed along the vehicle by removing the seals, starting from the tailgate to the dashboard, where the standard screen is located. Once the screen is removed, make the necessary electrical connections, and then you can refit the plastic trims and seals that were previously removed.


Updated on 10 June 2026 by ScegliAuto


Related tutorials

Volkswagen Golf (2008-2012 / Golf 6, MK 6, 5K1, Golf VI) To install the reversing camera on the Volkswagen Golf 6, connect the camera wiring to the car radio, routing all wires under the seals or beneath th…
Volkswagen Golf (2012-2019 / MK 7, Golf 7, Golf VII) This guide shows how to install the reversing camera kit for rear visibility when parking on the Volkswagen Golf seventh series. First, adapt the rev…
Volkswagen Golf (2008-2012 / Golf 6, MK 6, 5K1, Golf VI) To install the reverse camera on a Volkswagen Golf, loosen the screws securing the internal panel of the tailgate in place: once these screws are loo…

    Frequently Asked Questions

    • Golf 2008-2012 - Where is the parking sensor control unit of the Golf 6 located? Read answer

How to enter the radio code in the Opel Zafira?

In the Opel Zafira, it may happen that the radio locks and consequently requests the appropriate security code, especially after disconnecting or replacing the battery. The code can be found in the documents provided at purchase or through one of the various online recovery services. Once obtained, enter it by following the procedure shown in this tutorial. First, switch on the instrument panel, then press and hold both the "AS" button and the left knob for about 5 seconds. Next, enter the first digit by repeatedly pressing the "1" button, continue with the next 3 buttons, and save the setting by pressing the "AS" button again.

Watch the video!


by ScegliAuto

More videos