Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the front brake pads on the Yamaha NMAX 125 scooter?

Model: Yamaha Nmax 125
Part: Brake pads

Video tutorial

In this tutorial, you will learn how to replace the front brake pads on the Yamaha NMAX 125 scooter, a very simple and quick operation. First, position yourself in front of the brake in question, then unscrew the two fixing bolts of the caliper using a Torx T50 spanner.

Next, separate the caliper from the disc, release the two clips indicated, and remove the two pins. At this point, you can remove the old pads, clean any dirt residue, and fit the new ones.

To reassemble everything, simply follow the reverse procedure.


Updated on 29 October 2026 by ScegliAuto


Related tutorials

Replacement of the rear brake pads of the Yamaha Nmax 125
Replacement of the rear brake pads of the Yamaha Nmax 125
Nmax 125 The instructions in this guide will show us how to disassemble and replace the rear brake pads of the Yamaha Nmax 125 scooter. First, we put the scoo…
How to Reset the Service on the Yamaha NMAX 125 Scooter?
How to Reset the Service on the Yamaha NMAX 125 Scooter?
Nmax 125 In this tutorial, we will see how to reset the service on the Yamaha NMAX 125 scooter, a very simple and quick operation to perform only after comple…
How to Change the Engine Oil on a Yamaha NMAX 125 Scooter
How to Change the Engine Oil on a Yamaha NMAX 125 Scooter
Nmax 125 In this tutorial, you will see how to change the engine oil on a Yamaha NMAX 125 scooter, a very simple and quick operation. First, wait until the en…

How to Replace Engine Oil in the Husqvarna TE 610?

In this tutorial, you will see how to replace the engine oil in the Husqvarna TE 610, a very simple and quick operation. Before proceeding, wait for the engine to cool completely to operate safely. Start by removing the lower protection panel, then locate the drain bolt on the right side and loosen it using a 14 mm socket spanner. Once all the oil has drained from the system, remove the filter, clean it of any dirt residue, and reassemble everything. Finally, insert the required amount of oil through the upper hole.

Watch the video!


by ScegliAuto

More videos