Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Changing Brake Pads on a Yamaha R1

Model: Yamaha R1 Yamaha
Part: Brake pads

Video tutorial

Remove the bolts securing the brake caliper so you can work with the part in hand. Check the wear indicator: if it is close to the limit, before it reaches the metal, change the pads.

To remove them, simply take out the two pins by pinching and pulling out the small springs. The Yamaha R1 has 4 pads, two large and two small.

Open the caliper pistons by pushing them, as the new pads are obviously thicker since they are unworn, and you will need to create enough space. Start by inserting the smaller pads and secure them with the pins and springs.

Once all pads are in place, fit the caliper back onto the brake disc.


Updated on 31 March 2026 by ScegliAuto


Related tutorials

How to Replace the Front Brake Pads on a Yamaha R1
How to Replace the Front Brake Pads on a Yamaha R1
R1 Yamaha To replace the front brake pads on a Yamaha R1, completely remove the clip that secures the pin inside the caliper, which holds the pads in place. On…
How to Replace the Battery on the 2012 Yamaha R1
How to Replace the Battery on the 2012 Yamaha R1
R1 Yamaha In this video, you will see the steps to remove and replace the battery on the 2012 Yamaha R1. First, remove the rider's seat by unscrewing the fixin…
How to adjust the time on the Yamaha R1?
How to adjust the time on the Yamaha R1?
R1 Yamaha In this tutorial we can see how to adjust the time on the Yamaha R1, a very simple and fast operation, to be carried out for example after the switch…

How to change the transmission oil on the Honda PCX 150 scooter?

In this tutorial, you will see how to change the transmission oil on the Honda PCX 150 scooter, a very simple and quick operation. First, ensure the engine is completely cold, then locate the three bolts at the end of the casing and position a container underneath them. Next, remove the two inner bolts using a 12 mm socket, clean them of any dirt, and allow all the oil in the system to drain out. At this point, tighten the lower bolt and, using a pump or syringe, add new oil through the upper hole.

Watch the video!


by ScegliAuto

More videos