Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Engine Oil Change on Yamaha Ray ZR

Model: Yamaha Ray Zr
Part: Engine oil

Video tutorial

For this scooter model, it is recommended to use synthetic oil for engines 10W-30. Warm up the engine for a few minutes to reduce the viscosity of the lubricant, thus facilitating its subsequent drainage, but be careful not to burn yourself while working.

Unscrew the bolt located under the engine compartment that acts as a plug for the engine oil drainage hole.

Collect the oil in a container and dispose of it properly. Tighten the drainage hole and unscrew the filler cap: you will notice it by the slot on top, where you can insert a flat screwdriver to unscrew it. Pour in the amount of oil that was previously drained.


Updated on 3 April 2026 by ScegliAuto


Related tutorials

How to Change the Engine Oil on a Yamaha Ray ZR
How to Change the Engine Oil on a Yamaha Ray ZR
Ray Zr To change the engine oil on the Yamaha Ray ZR, you need to unscrew the oil drain plug located at the central lower part of the bike, just in front of…
How to replace the brake light bulb on the Yamaha Ray Rz 125
How to replace the brake light bulb on the Yamaha Ray Rz 125
Ray Zr In the following guide, we will discover together the steps you need to follow in order to correctly replace the brake light bulb of your Yamaha Ray …
How do you reset the engine light of the Yamaha Ray RZ?
How do you reset the engine light of the Yamaha Ray RZ?
Ray Zr In order to reset the engine light of the Yamaha Ray RZ, you need to connect a diagnostic tool to the OBD port of the vehicle: the OBD port will be l…

How to change the engine oil on the Aprilia Shiver 900?

To change the engine oil on the Aprilia Shiver 900, loosen the screws that secure the engine guard located at the bottom of the vehicle: once the screws are loosened, you can detach it and locate the drain plug of the oil sump. By removing this plug, you can collect all the used oil in a suitably placed container; at this point, allow all the oil to drain and remove the filter located at the bottom of the bike. Once the filter is replaced, top up the oil through the breather located on the right side of the bike.

Watch the video!


by ScegliAuto

More videos