Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Replacing the front bulb on a Yamaha YBR 125 is very simple, and now we will show you how. Start by unscrewing the screws that secure the round headlamp to the front fairing. At this point, pull it out of its housing, and you will notice something interesting: on this bike, there is no need to remove the rear cover of the headlamp as is often the case, because there is a hole in the same cover through which the cable passes to the bulb. Therefore, pull from the connector, not the wires, also extracting the bulb. Simply pull it by hand to remove it from the connector and insert the new one, then reassemble the headlamp.

Updated on 6 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Brake Light Bulb on a Yamaha YBR 125?
How to Replace the Brake Light Bulb on a Yamaha YBR 125?
Ybr 125 Replacing the brake light bulb on the Yamaha YBR 125, as shown in this tutorial, is an extremely simple and quick task. Before proceeding, ensure tha…
How to Dismantle the Rear Wheel of a Yamaha YBR 125
How to Dismantle the Rear Wheel of a Yamaha YBR 125
Ybr 125 Below are the instructions that will allow you to dismantle and remove the rear wheel of the Yamaha YBR 125. First, place the bike on a stand and sta…
How to Replace the Exhaust on the Yamaha YBR 125?
How to Replace the Exhaust on the Yamaha YBR 125?
Ybr 125 To replace the exhaust on the Yamaha YBR 125, loosen the bolts securing it to its housing at the rear of the bike, right next to the rear wheel: once…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos