Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Air Filter on a Yamaha YBR-G?

Model: Yamaha Ybr 125
Part: Air filter

Video tutorial

To replace the air filter on a Yamaha YBR-G, loosen the screws securing the cover located on the left side of the bike, just under the seat. Once all the screws are removed, open the cover and extract the air filter inside.

After removing the old filter, insert the new replacement into its housing. Once the new filter is in place, close the protective cover by screwing it back on with the appropriate screws.


Updated on 4 May 2026 by ScegliAuto


Related tutorials

How to Replace the Air Filter on a Yamaha YBR 125
How to Replace the Air Filter on a Yamaha YBR 125
Ybr 125 To replace the air filter on the Yamaha YBR 125, you need to unscrew the bolts securing the cover located on the right side of the bike, just below t…
How to Replace the Battery on a Yamaha YBR 125
How to Replace the Battery on a Yamaha YBR 125
Ybr 125 To replace the battery on a Yamaha YBR 125, insert the key into the lock located on the left side of the bike, just below the seat. This will allow y…
How to Replace the Exhaust on the Yamaha YBR 125?
How to Replace the Exhaust on the Yamaha YBR 125?
Ybr 125 To replace the exhaust on the Yamaha YBR 125, loosen the bolts securing it to its housing at the rear of the bike, right next to the rear wheel: once…

How to change the engine oil of a Yamaha MT-07?

To change the engine oil of a Yamaha MT-07, follow these steps. Start by placing the bike on a flat surface and ensure the engine is warm but not too hot. Remove the oil cap from the top of the engine and unscrew the oil drain plug on the engine casing, usually located on the underside of the engine. Position a collection container under the drain plug and unscrew the plug to completely drain the used oil. Once drained, refit the drain plug. Remove and replace the oil filter using an oil filter spanner. Apply a little new oil to the seal of the new filter before installation. Fill the engine with new oil through the oil opening until reaching the recommended level. Check the oil level using the dipstick and add oil if necessary. Refit the oil cap and ensure it is securely tightened. Start the engine and let it run for a few minutes to distribute the oil, and you will have completed the procedure.

Watch the video!


by ScegliAuto

More videos