|
Do it yourself
| |||
| ||||
|
Model: Yamaha Xmax 300
To reset the V-Belt warning light on the Yamaha Xmax 300, insert the key into the ignition and turn it to switch on the instrument panel. To reset the warning light, pull the lever located at the base of the right handlebar inwards. While holding the lever, the light will start to flash until the kilometres remaining until the next replacement are reset. Once the kilometres have increased, you can release the lever and turn off the ignition by rotating the key counterclockwise.
Updated on 8 June 2026 by ScegliAuto
Video tutorial
Related tutorials
Xmax 300
.. To reset the V-Belt warning light on the Yamaha Xmax 300, insert the key into the ignition and turn it to switch on.. …
Xmax 300
Today we will see the information related to the reset of the transmission belt change warning for the Yamaha Xmax 300 scooter. First, we put the sco…
Xmax 300
To reset the Service light on a Yamaha Xmax 300, turn on the instrument cluster by rotating the key in the ignition switch: once the cluster is on, n…
|
How to Service the Beta RR 350
This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level! by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.143
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |