Do it yourself
| ||||
|
Alfa Romeo Giulietta - Video tutorial
Model: Alfa Romeo Giulietta
MK 1
- Years 2010-2020 Today we will explain the steps to use to disassemble the EGR valve on an Alfa Romeo Giulietta vehicle. The first step to perform is to open the engine hood. The second step is to remove the connector from the intake duct. The third step is to remove the connector and nut that secure the valve located near the engine under the water pipes. The fourth step is to clean the valve housing. The steps for reassembling the car are the same but done in reverse. Once finished, close the front hood.
Posted on 18 April 2024 by ScegliAuto
Other guides that may interest you
|
How to reset the tire pressure warning light on Dacia Sandero?Let's see below how it is possible to reset the low tire pressure signal on the car: first of all it is necessary to check the correct tire pressure by comparing it with the pressures reported in the use and maintenance manual. After that, turn on the ignition and locate the command on the right side of the steering wheel at the top that allows you to access the on-board computer menu, then select the car symbol, after which select the "up arrow" command up to that the indication "tire pressure" appears on the display. At that point, press the "Ok" control on the steering wheel and keep it pressed to reset the signal. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.019
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |